Herunterladen Diese Seite drucken

Assembling The Lawn Scarifier - Stihl Rla 240.0 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für RLA 240.0:
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

7 Assembling the Lawn Scarifier

mation on charging times, see www.stihl.com/
charging-times.
► Charge the battery as described in the STIHL
charger operating instruc‐
tions AL 101, 301, 500 .
6.2
Displaying the state of charge
1
► Depress the pushbutton (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3
LEDs on the Battery
The LEDs can indicate the battery charge state
or faults.The LEDs can illuminate or flash green
or red.
If the LEDs light up or flash green, the charge
state is being indicated.
► If the LEDs light up or flash red:remedy the
faults,
19.1.
There is a fault in the lawn scarifier or in the
battery.
7
Assembling the Lawn
Scarifier
7.1
Attaching the Handlebar
► Switch the lawn scarifier off and remove the
battery.
► Place the lawn scarifier on a level surface.
0478-670-9911-A
80-100%
60-80%
40-60%
20-40%
0-20%
► Open both quick-release levers (1) and fold
► Slide the cable guide (3) onto the screw (4).
► Align centre handlebar section (5) on the lower
► Push the screws (4, 6) through the holes from
► Slide the cable guide (9) onto the screw (10).
► Align the upper handlebar section (11) with the
► Push the screws (10, 12) through the holes
► Press the cable (15) into the cable guides (3,
► Adjust the handlebar to the desired height
The handlebar must not be dismantled again.
7.2
► Switch the lawn scarifier off and remove the
the lower handlebar section (2) backwards,
hold it at the desired height and close both
quick-release levers (1) again.
handlebar (2) so the bores align.
the outside, insert a washer (7) on the inside
and fix them in place with the turning handles
(8).
handlebar centre sections (5) so that the holes
are aligned.
from the outside, place a washer (13) onto
each on the inside and fix in place with the
rotary handles (14).
9).
using the quick-clamping device (1)
Removing the Combing Roller
from the Transport Compart‐
ment Before Use for the First
Time
battery.
English
8.1.
33

Fehlerbehebung

loading