Operation; Activating The Controller's Data Outputs - EuroLite LED PIXEL POLE Bedienungsanleitung

6

OPERATION

The built-in control panel of the controller features four operating buttons and a display which shows all
operation statuses. After switching on the unit, it requires a short initialization process and is then ready for
operation. The display shortly indicates the firmware version followed by the last operating mode. The
operating modes can be selected by means of the display and the control buttons. After switching the
controller off and on again, the operating mode selected last is activated.
► Operating Buttons
MODE
UP
DOWN
ENTER
► Menu Structure
Auto Mode
Program
Speed
Slave Mode
Yes/No
Network Settings
IP Address
Subnet Mask
Net Subnet Unive
Universe Export
1-4
Software Version
Version X.X
Notes:
• The display shuts off after 20 seconds of inactivity. With the touch of a button it lights up again.
• After the controller's IP address has been changed, shortly turn the controller off and on again to make this
change effective.

Activating the Controller's Data Outputs

The controller's data outputs need to be activated.
1
Press MODE to call the menu and select <Universe Export> with the buttons UP and DOWN. Confirm
with ENTER.
2
Use the buttons UP and DOWN to adjust the desired number of outputs and confirm with ENTER.
www.eurolite.de
Selects the menu./Returns to the initial screen.
Selects the next menu item or increases values when modifying.
Selects the previous menu item or decreases values when modifying.
Activates a value to be modified or saves a value when modifying.
Automatic mode
Selects program 1 to 30
Sets running speed slow
Slave mode
Yes/no
Network settings
Input the controller's IP address
Input the subnet part of the address
Input the universe part of the address
Data signal outputs
Activates output 1 to 4
Firmware
Displays the firmware version
fast
19