Master/Slave Operation; Connection With The Mains; Operation - EuroLite LED CBC-9x15W COB RGB Bedienungsanleitung

Connection between devices
On the rear panel, there is an IEC socket (Power Out). Connect the output with the input of the next fixture
until all fixtures are connected.
Attention: It is recommended to renew the connection with the power mains after every 8 devices.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Please see further instructions under Operation.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the EUROLITE LED CBC-9x15W COB RGB starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and
DOWN. The desired setting can be chosen and changed as long as the LED display information blinks.
The device has two operating modes. It can be operated in Stand Alone via LED display with operating
buttons or alternately in DMX-controlled mode via lighting controller.
- STAND ALONE MODE
Solid colors and color combinations
•
• Auto
Speed
•
Sound control
•
Sensitivity
•
User settings
•
Dimmer
•
Ventilation
•
• Linking
• Master/Slave
- DMX MODE
DMX Addressing
•
DMX Channel Mode
•
International
L
N
28/39 00078358.DOC, Version 1.0