Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
After you connected the effect to the mains, the LED TMH-12 starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.
Stand Alone operation
In the Stand Alone mode, the LED TMH-12 can be used without controller.
Disconnect the LED TMH-12 from the controller and call the internal program. Please refer to the instructions
under Control Board.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT jack with the DMX IN plug of the next device.
Set the desired Master-mode - „DMX Mode", „Auto Mode" or „Sound" - for the master-device, as described in
chapter Control Board. Set the DMX address 1 for all slave-devices.
DMX-controlled operation
You can control the projectors individually via your DMX-controller.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-12 will respond to the controller.
If you set, for example, the address to channel 13, the device will use the channel 13 to 24 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-12 correctly
and independently from any other fixture on the DMX-chain.
If several LED TMH-12 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-12 via your lighting controller.
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the DMX indicator will be flashing. If there is no data received at the DMX-input, the DMX
indicator does not light up.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
22/28
00074204.DOC, Version 1.1
Werbung
Inhaltsverzeichnis
