Operation; Connection With The Mains; Cleaning And Maintenance - EuroLite Work Light 230V/32W E-27 ES Bedienungsanleitung

For the installation, you need one 230 V/32 W E-27 Engergy Saving lamp.
Procedure:
Step 1: Carefully unscrew the housing at the black connecting ring.
Step 2: If replacing the lamp, remove the old lamp from the lamp holder.
Step 3: Insert the lamp into the lamp holder.
Step 4: Replace the housing parts and screw together.

Operation

Unpack the Work Light and place on a flat surface.
Adjust the desired inclination-angle and tighten the fixation screw.
Carry the Work Light via the comfortable handle to the desired place for use.

Connection with the mains

Connect the device to the mains with the power-plug.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the lamp. Maintenance and service operations
are only to be carried out by authorized dealers.
Please refer to the instructions under "Installing/Replacing the lamp".
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
Do not operate this device with opened housing!
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
11/12 00041964.DOC, Version 1.1