Operation; Stand Alone-Mode; Auto Mode - EuroLite LED PST-15W QCL Bedienungsanleitung

If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the EUROLITE LED PST-15W QCL DMX Spot to the mains, the device starts running.
The LED display lights up and you can now choose the desired settings via the buttons MODE, ENTER, UP
and DOWN.
- STANDALONE-MODE
- Setting Solid Colors

- Auto Mode

- Sound Mode
- Master/Slave Mode
- DMX MODE

Stand Alone-Mode

Setting solid colors
Press the MODE button until the LED display shows "C---", then press the ENTER button to confirm.
The desired color can be selected via the UP or DOWN buttons, then press the ENTER button again to
confirm.
Please see the following table for a listing of solid color settings.
Program:
C 1
C 2
C 3
C 4
C 5
C 6
C 7
C 8
C 9
C10
C11
C12
C13
C14
C15
Auto Mode
In Auto Mode the internal program is called up automatically in a continuous loop.
Press the MODE button until the LED display shows "P---", then press the ENTER button to confirm
The desired program can be selected via the UP or DOWN buttons, then press the ENTER button again to
confirm.
Color:
Red
Green
Blue
White
Red + Green
Red + Blue
Green + Blue
Red + Green + Blue
Red + White
Blue + White
Green + White
Red + Blue + White
Green +Blue + White
Red + Green + White
Red + Green + Blue + White
20/23 00065717.DOC, Version 1.1