Atlas Copco EP 7PTX-55 HR10-RE Produktanweisungen Seite 5

EP7PTX55 HR10-RE
For more information please read, Atlas Copco Industrial Power Tools cata-
logue Ordering No. 9837 3000 01.
Handling
Setting of tightening torque
The adjusting screw (the slotted screw) is the only screw that initially
should be adjusted.
Start at a low torque adjustment and gradually increase the setting until you
reach the desired torque level. Using the machine above recommended maxi-
mum torque might result in improper function and faster wear.
Always check the setting on your actual joint.
see Service Instructions.
RE-version
At hard joints and low tightening torque settings, reduced free speed by the
Trim-valve will improve the accuracy.
Reporting, RE-signal
Reporting (RE) machines supply an air signal that can be connected to a moni-
toring instrument that counts the number of approved tightening and detects
premature shut-off and rehits and other irregularities.
Test method - Static or Dynamic
A static torque measurement is recommended for the ErgoPulse machines.
If dynamic torque measurement with an electronic inline torque transducer is
used, always verify your measurement result by a static check with a torque
wrench (electronic).
For more information, read Atlas Copco "Pocket Guide to Pulse Tools". Order-
ing No. 9833 1225 01.
Maintenance
For maximum performance
At tough working conditions – soft joints and max. setting – lubrication of the
air is recommended.
With extreme dry air the service life of vanes and machine performance might
be reduced. A daily supply of 0.1 – 0.2 ml oil into the machine inlet will im-
prove the machine performance. Alternatively consider an automatic lubricator
device, Atlas Copco oil fog lubricator DIM, or single point lubricator DOS,
which will improve the machine performance.
EN
© Atlas Copco Industrial Technique AB - 9836 950700 00
Safety and operating instructions
5