Atlas Copco EP 7PTX-55 HR10-RE Produktanweisungen Seite 3

EP7PTX55 HR10-RE
Safety and operating instructions
Safety instructions
Warning
• Make sure you are familiar with the operating instructions before you use
this machine.
• Before making any adjustments (e.g. setting the torque, changing bits) dis-
connect the machine from the compressed air line.
• The machine, together with any attachments and accessories, must never be
used for anything other than the designed purpose.
• Use power sockets only. For safe and economic use - replace worn sockets.
• Check that the power socket is properly fastened - replace the square drive
retainer when necessary.
• Keep your fingers away from the power socket during operation to avoid in-
jury.
• Never work without protective goggles.
• Avoid unnecessary idling.
• When using a suspension yoke, check that it is in good condition and cor-
rectly fastened.
Warning
Disassembly and assembly precautions
The rotor blades (vanes) in the tool contains PTFE. The normal health and
safety recommendations concerning PTFE must be observed when handling
these rotor blades. Particles from wear of blades might be found in the machine
housing or on the blades. Make sure that these particles do not get in contact
with open fire. Wash your hands before smoking since PTFE-particles heated
by glow can produce fumes which may cause an allergic reaction.
General information
EC DECLARATION OF CONFORMITY
We, Atlas Copco Industrial Technique AB, S-105 23 STOCKHOLM, SWE-
DEN declare that the product (with name, type and serial number, see front
page) is in conformity with the following Directive(s):
2006/42/EC
Harmonised standards applied:
ISO 11148-6
Technical file available from:
Quality Manager, Atlas Copco Industrial Technique, Stockholm, Sweden
Stockholm, 1 July 2013
Tobias Hahn, Managing Director
Signature of issuer
EN
© Atlas Copco Industrial Technique AB - 9836 950700 00
Safety and operating instructions
3