Silvercrest SHH 150 C1 Kurzanleitung Seite 18

Wall mounting: To avoid danger
to children, the product must be
mounted with its underside at
least 60 cm above the ground.
Mount the product so that
the on/off switch cannot be
operated by a person in the
bathtub or shower.
Inspect the product for any
visible damage before use. Do
not operate a product that has
been damaged or fallen.
This product is not equipped
with a unit for controlling the
room temperature. The product
must not be used in small
rooms inhabited by persons
who cannot leave the room
independently, unless continuous
monitoring is guaranteed.
WARNING! Hot
surfaces! Some parts of
the product may become
very hot and can cause burns.
Special care should be taken
when children and vulnerable
persons are present.
Defective components may
only be replaced with genuine
spare parts. Only genuine
parts guarantee that safety
requirements are met.
Protect the product from moisture
and liquid penetration.
18 GB/IE
Only disconnect the power cord
from the socket at the power
plug, not with the cable.
Do not operate the product in
the vicinity of naked flames.
Do not install the product
directly under or above a socket-
outlet.
In case of any malfunctions or
thunderstorms, disconnect the
power plug from the socket-
outlet.
Never use the product near a
bathtub, shower or swimming
pool.
Only use the product with the
power cord fully unrolled. Never
wrap the power cord around the
product. Take care to ensure that
the power cord does not come
into contact with hot surfaces.
Route the power cord so that it is
not possible to trip over it.
m WARNING! This product is
intended only for drying textiles
washed in water.
˜ Installation
NOTE: The product can be operated free-standing or wall-
mounted.
˜ Free-standing
(fig. B)
Attach the feet to the underside of the towel holder
[ 6 ]
with 2 screws (M4 x 14 mm, blunt)
1 ] [
each.
[ ]