Stihl RLE 240 Gebrauchsanleitung Seite 34

English
► Upend the lawn scarifier.
► Clean the area around the roller and the roller
with a soft brush or a damp cloth.
16 Maintenance
16.1 Maintenance Intervals
Maintenance intervals are dependent on the
ambient conditions and the working conditions.
STIHL recommends the following maintenance
intervals:
After every fifth change of rollers
► Have the roller fastening screw replaced by a
STIHL specialist dealer.
Annual
► Have the lawn scarifier serviced by a STIHL
specialist dealer.
The current addresses of the specialist dealers
can be found under the respective STIHL country
representative at www.stihl.com .
16.2 Removing and Attaching the
Roller
16.2.1 Detaching the Roller
► Switch the lawn scarifier off and detach the
extension cable connector from the mains plug
of the lawn scarifier.
► Upend the lawn scarifier.
1
1
18 Troubleshooting
18.1 Remedying Lawn Scarifier Faults
Fault
The lawn scarifier
does not start when
switched on.
34
2
3
Cause
The plug or extension cable connector
are not plugged in.
The circuit breaker (fuse) or the resi‐
dual current device tripped. The circuit
is electrically overloaded or defective.
► Unscrew screws (1).
► Remove installed roller (3) together with
holder (2).
16.2.2 Attaching the Roller
► Switch the lawn scarifier off and detach the
extension cable connector from the mains plug
of the lawn scarifier.
► Upend the lawn scarifier.
1
1
4
► Insert scarifying roller (2) or combing roller (4)
together with holder (3) into the mount.
► Install screws (1) and tighten firmly.
17 Repairing
17.1 Repairing the Lawn Scarifier
The user should not repair the lawn scarifier or
rollers themselves.
► If the lawn scarifier or rollers are damaged: do
not use the lawn scarifier or rollers and consult
a STIHL specialist dealer.
► If warning signs are illegible or damaged: have
the warning signs replaced by a STIHL spe‐
cialist dealer.
Remedy
► Insert the plug and extension cable
connector.
► Find and fix the cause of the circuit
breaker or RCD tripping. Insert the
circuit breaker (fuse) or residual cur‐
rent device.
► Switch other power consumers in
the same circuit off.
16 Maintenance
2
3
0478-670-9910-C