Parkside PLSA 40-Li D2 Bedienungsanleitung Und Originalbetriebsanleitung Seite 51

NOTE
Carry out the cleaning and maintenance
u
work described in the following sections
on a regular basis. This will ensure a long
and reliable service life.
˜ Cleaning
m WARNING! Risk of electric shock!
Do not spray the product with water and
u
do not immerse it in water.
m NOTICE! Risk of damage to the
product!
Do not use any cleaning agents or
u
solvents. You may irreparably damage
the product. Chemical substances may
attack the plastic parts of the product.
Clean the following parts with a damp cloth
o
or a brush:
Ventilation slots
–
Motor housing
–
Handle
– 4 ] [
Auxiliary handle
–
Clean the collection bag
o
or, if necessary, with compressed air.
˜ Maintenance
Prior to every use, check the product for
o
obvious defects such as loose, worn or
damaged parts.
Check covers and safety devices for
o
damages and correct installation. If
necessary, have these parts replaced.
˜ Removal of clogging and
blockage
NOTE
Leaf material and fresh plant parts may
u
clog or block the product.
50 GB/IE
[ ]
2 ] [
[ ]
with a brush
[ ]
Cleaning the impeller wheel
m CAUTION! Risk of injury!
Remove the battery packs
u
cleaning the impeller wheel.
1. Open the protective cover
the suction pipe
[
2. Carefully remove residues or clogging
materials from the impeller wheel.
3. Check if you can easily rotate the impeller
wheel and if it is in undamaged condition.
Have a defective impeller wheel replaced
by our Service Centre (see "Service").
4. Close the protective cover
suction pipe (see "Assembly").
[ ]
NOTE
If the protective cover
u
pipe is not installed correctly, you
[ ]
cannot operate the product.
˜ Storage
You can dismantle the product for space-
o
saving storage (see "Assembly").
Store the product in a dry place well out of
o
reach of children.
Remove the battery packs
o
the product for a longer period of time (e.g.
over winter).
Observe the information in the user manual
o
for the battery packs
permissible storage temperature. Avoid
extreme cold or heat during storage to
ensure the battery output is not adversely
affected.
˜ Transport
Switch off the product and remove the
o
battery packs .
7 ] [
Let all moving parts come to a complete
o
stop.
Always carry the product by the handle
o
and the auxiliary handle
before
[ 7 ]
or remove
8 ] [
(see "Assembly").
]
or install the
8 ] [
or the suction
[ 8 ]
before storing
[ 7 ]
regarding the
[ 7 ]
4 ] [
.
[ ]