Wmf Pre-Brewing System; Change The Coffee Quantity (Teach-In Function); Information About The Programming Mode; Resetting To Delivery Condition - WMF LONO Gebrauchsanweisung

WMF Pre-Brewing System

The pump first only conveys a small amount. The brewing process first continues
only after a brief pause, during which the coffee powder can swell. A particularly
intensive flavour is achieved in this way.
4. If you would like to cancel the process early, press the start button again.
5. Turn the adjusting knob (10) back to the home position
more liquid is being dispensed.
Tip
▪ Stir the coffee before drinking it so as to achieve a uniform coffee strength in
the cup.
▪ For hygienic reasons, remove the used coffee pads from the pad cartridge (9)
as soon as possible.
▪ Seal the packaging used to store the pads to prevent the loss of aroma.
▪ Fill with fresh tap water every day. Rinse the water tank (11) with tap water
just before use. Then carry out a rinse procedure.

Change the coffee quantity (Teach-In function)

The coffee pad machine offers the convenient option of programming the desired
coffee quantity individually for each start button
dently of each other. You can therefore change the strength of the coffee accord-
ing to your personal needs:
1. Insert the pad as described above, turn the adjusting knob (10) in the range
(A) as far to the right as possible and wait until the On / Off button (4)
illuminates white.
2. Hold down the start button
the On / Off button (4) flashes white (approximately 4 seconds). The program-
ming mode is now active during brewing. Watch as the cup is filled. Once the
desired quantity is reached, press the same start button again. The brewing
is stopped and the brew time (on-time of the pump) is programmed. Every
brewing with this start button now always takes place with the same brew
time. The prepared coffee quantity will only differ slightly depending on the
quality of the coffee.

Information about the programming mode

The programming mode is active during brewing for approximately 30 seconds
or approximately 60 seconds
the brewing stops automatically, then the maximum possible fill amount is
programmed.

Resetting to delivery condition

Proceed as follows to reset the fill amount back to the delivery condition:
1. Switch off the appliance.
2. Hold down both start buttons
On / Off button (4) flashes briefly.
(C) as soon as no
(3) or
(3) or
(5) that is to be programmed until
. If you do not push the start button before
(3) and (5) (3 to 4 seconds) until the
(5) indepen-
27