Coffee; Coffee Soft Pads; Pad Cartridge; Preparation - WMF LONO Gebrauchsanweisung

Coffee

Coffee soft pads

You can use all standard coffee soft pads with an external diameter of 7 cm (cof-
fee quantity approx. 7 g). Coffee pads with a smaller diameter do not produce the
best tasting coffee. Hard pads which are offered for espresso machines and pads
with additives for cappuccino, or similar, must not be used.
Never put damaged pads, loose coffee powder or instant coffee into the pad
cartridge (9) as it would clog and block the adjusting knob (10) so that the pad
cartridge (9) can no longer be removed. Should this nevertheless happen once,
please read the instructions in the section "Troubleshooting."
The amount of coffee powder in a pad is optimally adjusted to a 125 ml cup. The
following fill amounts are pre-configured when delivered to the customer:
Start button
Start button
You can vary the filling quantity per cup as per your personal needs, allowing
you to vary the strength of the coffee. Read the section "Programming mode" for
more.

Pad cartridge

Turn the adjusting knob (10) to the position
home position
brewing chamber somewhat to facilitate removal.
The pad cartridge (9) can be used from two sides. The side marked with  is for a
coffee pad and the side marked with  is for two coffee pads.
The more carefully you insert the coffee pads, the better the coffee will taste. It is
therefore important to adhere to the following instructions:
▪ Evenly distribute the powder in the coffee pad up to the rim before insertion.
▪ Using one coffee pad:
After insertion, lightly pat the coffee pad with your fingertips so that a small
depression is created in the middle. Ensure that the paper edge of the coffee
pad is lying flat in the depression of the pad cartridge (9) and does not stick
out or fold inwards.
▪ Using two coffee pads:
Press the lower coffee pad firmly into the recess of the pad cartridge (9). The
paper edge will point upward here. Then insert the second coffee pad accord-
ing to the procedure described above for one coffee pad.
▪ When inserting the pad cartridge (9), ensure that the pad is not displaced, as
otherwise the seal will not close properly.
▪ Turn the adjusting knob (10) as far to the right as possible in the range

Preparation

1. Place one cup in the middle or two cups next to each other on the grate insert
(1) (see figure).
You can use cups with a height of up to 10 cm.
2. Wait until the On / Off button (4) illuminates white.
3. Depending on whether you have prepared one or two cups, press the cor-
responding start button
white during preparation.
26
(3) approx. 125 ml ideal for 1 pad
(5) approx. 250 ml ideal for 2 pads
(C). As a result, the pad cartridge (9) will be pushed out of the
(3) or (5). The On / Off button (4) illuminates
(D) and then right back to the
(A).