Installation, Connecting-Up - Siemens simovert masterdrives Betriebsanleitung

11.2006
3

Installation, Connecting-up

NOTES
Siemens AG 6SE7087-6CX84-3DB0
SIMOVERT MASTERDRIVES
The board is snapped onto a mounting rail. The components must be
wired-up by others.
♦ The board provides no protection against direct contact. Protection
against direct contact is ensured by mounting it in an enclosure or in
a cabinet.
♦ Screened cables must be used to prevent EMC disturbance.
Screens must be connected at X80 and X81.
♦ Perfect functioning of the board cannot be guaranteed if the
permissible cable lengths are exceeded (refer to figs. 5-1 to 5-4). If
longer cable lengths are required, please contact your tachometer
manufacturer or supplier.
♦ Power- and control cables must be separately routed.
Terminal Function, information
X401: TTL tachometer
1 Reference potential (M tachometer)
2 Pulse track A
3 Inverted pulse track A
4 Pulse track B
5 Inverted pulse track B
6 Position track (not evaluated)
7 Inverted position track (not evaluated)
8 Tachometer monitoring track (not
evaluated)
9 Inverted tachometer monitoring track
10 5 V tachometer supply
1)
American Wire Gauge
Digital tacho-Interface
Installation, Connecting-up
Cable cross-section
2 1)
[mm ] AWG
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
3-1