BWT MIXXO Bedienungsanleitung Seite 12

4.3 BWT MIXXO main unit
There are also light signals on the BWT MIXXO
main unit that indicate status, capacity and va-
rious warnings:
Overview: BWT MIXXO light signals
Green = Stand-by
BWT MIXXO in standby mode
Green fading =
Tap water is supplied unfiltered to
the faucet
Blue fadinG =
EN
filter system is activated
Filtered water is supplied to the
faucet
4.4 BWT Home App
The BWT Home App is a key component of this
product. In our BWT Home App you will be gui-
ded through the installation, settings can be
made and the filter cartridge can be reset after
replacement. You will also receive warnings and
information about the functionality of the pro-
duct and its capacity directly in the BWT HOME
APP.
22
BWT MIXXO
LED Signal
Signal Lights:
Yellow = Warning
e.g: Capacity of the filter cartridge
soon exhausted (below 10 % or
below 14 days)
RED = Warning
e.g: Capacity of the filter cartridge
exhausted
Service-Hotline
DE: 0800 112 23 22
AT: 0800 800 555
5. Troubleshooting
Error Cause
Water supply or shut-off valves are
closed
Filter cartridge not fully screwed
into the filter head
No supply of water
Filter head incorrectly mounted
No power supply
Low water flow rate System pressure too low
Screw connection
Seal defective or missing
leaking
Switching to filtered Incorrect installation
water is not possible Remote control is not charged
Too little space for
Check required distances
installation
6. Disposal
This product consists of various materials that
must be disposed of properly. If local collecting
points are available, recycle the packaging to
protect the environment.
Please consider applicable local regulations!
Batteries and rechargeable batteries are mar-
ked with the crossed-out wheeled garbage can
symbol. Disposal of batteries with household
waste is prohibited. All electronic parts should
only be disposed of at authorized recycling col-
Troubleshooting
Check/open valves
Unscrew the filter cartridge by ½
turn and screw it back in
Flow direction - check direction
arrow on filter head and reverse
if necessary
Check power supply
Check system pressure
Check seal, replace with new seal
if necessary
Carry out/repeat installation
using the app
Charge the remote control
Installation using extension hose.
Connection set optionally availa-
ble from BWT.
lection points (2012/19/EU). The respective na-
tional regulations for the disposal of electrical
appliances must be observed.
EN
23