Problem Chart - Omnitronic PM-3010 Bedienungsanleitung

8 PROBLEM CHART

PROBLEM
The power does not
turn on.
There is little or no
sound.
There is noise or
distortion.
Crossfading does not
work.
CAUSE
• The power cable is not connected.
• The input selector switch is in the
wrong position.
• The
rear input selector
PH/LINE is set to LINE although a
turntable is connected.
• The
connection cable
connected properly or not connected at all.
• The terminal or plug is dirty.
• The master level is too low.
• The master level is too high.
• The input level is too high.
• The
rear input selector
PH/LINE is set to PH although a unit
with line level output is connected.
• The assignment of the assignment
switches overlaps.
• Connect the cable to a power outlet.
• Set the selector switch to the correct
signal source.
• Set the input selector switch PH/LINE
switch
to PH.
• Connect the cable properly.
was not
• Clean and reconnect.
• Increase the level with the master
control or control.
• Via the output meter, adjust the
master level to an optimum level with
the master control.
• Via the level indication, adjust the
channel to an optimum level with the
gain control.
• Set the input selector switch PH/LINE
switch
to LINE.
• Select the correct signal sources for
crossfading
switches.
30/31
REMEDY
with the assignment
00043092.DOC, Version 2.0