Omnitronic PM-3010 Bedienungsanleitung Seite 26

3 For prefader listening to the input channels or for monitoring the current music program ahead of the
master control and the output controls ZONE and BOOTH, it is possible to connect stereo headphones
to the front input HEADPHONES via a 6.3 mm plug.
4 For connecting amplifiers, several stereo outputs with individual level controls are available:
• Connect the main amplifier to the master output, optionally to the balanced XLR or unbalanced RCA
output.
• For PA application in a secondary room, connect the amplifier to the stereo output ZONE.
• If a monitoring system is available, connect the amplifier of the monitoring system to the stereo output
BOOTH.
5 For analog sound recordings, connect the recording unit to the output REC(ORD). The recording level is
independent of the position of the master control and the output controls ZONE and BOOTH. With an
audio interface such as the OMNITRONIC DDI 4x4 you can also digitize the analog output signal of
the PM-3010 and transfer it to a computer with USB 1.1 or 2.0 connection.
6 A further mixer for team routines may be connected to the input SESSION.
7 Connect the power supply unit to the AC input of the PM-3010 and the mains plug to a mains socket.
Use the unit only with the supplied power unit. Always disconnect the mains connector when you wish to
change connections, move the unit to a different place or if it is not used for a longer period.
26/31 00043092.DOC, Version 2.0