Omnitronic PM-3010 Bedienungsanleitung Seite 23

18 Selector switch CUE SPLIT
For selecting the monitoring mode for the headphones
output:
• SPLIT (button pressed, red LED lights): The prefader
level (mono) is on one side and the output signal (mono)
is on the other side of the headphones.
• MIX (button released, blue LED lights): A mixed signal
of prefader level and master signal is on both sides of
the headphones.
19 Level control CUE LEVEL
Level control for the headphones output.
20
Headphones input
Input (6.3 mm jack) for connecting stereo headphones
(impedance Q8 ).
21 Control CUE MIXING
For selecting and crossfading the monitoring signal for
the headphones output:
• left stop position CUE: The prefader level of the input
channel of which the button CUE is pressed is
monitored.
• right stop position MASTER: The music program
currently playing is monitored ahead of the master fader
and the output controls ZONE and BOOTH.
22 Selector switch X-FADER REVERSE
Reverses the assigned channels for the crossfader.
• upper position: the assigned channels are on their
usual sides (control indicator off)
• lower position: the assigned channels are reversed
(red LED lights)
23 X-FADER CURVE control
For continuously adjusting the characteristic of the
crossfader.
• left stop position: smooth crossfading (gradual
transition) e.g. for long mixes
• right stop position:
transition) e.g. for scratching and cutting
24 Microphone input DJ MIC
Input for connecting a DJ microphone via an XLR plug or
6.3 mm plug.
23/31
sharp crossfading (abrupt
00043092.DOC, Version 2.0