Connecting Power; Power On/Off - AX Quadbox HD 2400 Bedienungsanleitung

3. Connecting Power

An A/C adapter and a power cord are provided as the basic accessories of the receiver.
• Connect the A/C adapter to DC IN at the rear panel of the receiver.
• Connect the power cord to the A/C adapter.
• Connect the power cord to a power outlet.
• Turn on the power switch at the rear panel.
NOTE: AC input condition
• Nominal Voltage Range: 100 – 240 VAC
• Maximum Voltage Range: 90 – 264 VAC
• Nominal Frequency: 50 / 60 Hz
• Maximum Frequency: 47 – 63 Hz
NOTE: means Remote control operation order.

4. Power ON/OFF

[ : Press Power
There are several ways to turn your
• Complete Power Shutdown
There is a Power Switch in the rear panel and once it is ON, you do not need to turn it on or off
each time.
It takes a longer time to boot the system if you turned it off by this switch.
• Standby Mode
POWER key is normally used to turn the power of the receiver on or off. If you press POWER, it
instantly switches your receiver. Off or On in this mode, the system is not completely shutdown
and thus it sakes a shorter time to turn it on and off.
• Deep Standby Mode [
Deep Standby is used to reduce standby power consumption. the receiver is designed to be
energy efficient and to guarantee the power consumption to be under 1W in the deep standby
mode.
18
key / Press Menu
receiver
: Menu > Standby/Restart > Deep Standby]
> Select Standby / Reset]
ON or OFF