SPARX SHARPENER 3 Bedienungsanleitung Seite 23

ADDITIONAL SHARPENING
GOALIE SKATES
To watch the How-To video, visit
Goalie risers are only necessary if your skate has a cowling. Goalie
skates without a cowling you may sharpen normally without risers.
If your skate does have a cowling, follow the steps below.
1
INSTALL THE GOALIE RISERS
Align the Anchor Pins (A) of the
Slots of the Skate Clamp. Once aligned, press down firmly until
Goalie Risers
you feel the snap into place.
sparxhockey.com/howto
Goalie Risers to the Anchor
A
2
CONTINUE THE SHARPENING PROCESS
Refer to "Loading a Skate" in the Operation section of the
manual. When adjusting the
graphic in step 3.
3
ADJUST THE GRINDING RING HEIGHT
Refer to "Adjusting the Grinding Ring Height" in the Operation
section of the manual using the figure below as your guide
where the desired contact point is A, contact point B is too high
and contact point C is too low.
5
CONTINUE THE SHARPENING PROCESS
Refer to "Sharpening Skates" in the Operation section
of the manual.
6
REMOVE THE GOALIE RISERS
Pull up on each end of the Goalie Risers
Skate Clamp.
6
Grinding Ring Height, refer the
B
A
C
to remove from the
OPERATION
19