SPARX SHARPENER 3 Bedienungsanleitung Seite 15

ASSEMBLING THE SHARPENER
To watch the How-To video, visit
1
INSTALL THE CLAMP LEVER
Slide the Clamp Lever (A) onto the
lever down until it clicks into place. When the
engaged, it will lay at a slight angle.
A
B
2
REMOVE THE TRAVEL GUARD
Open the Skate Clamp by pressing and holding down the
Clamp Lever. Remove the Travel
Transporting or moving the Sharpener without the
Travel Guard installed voids your Warranty and/or
Extended Service Plan. Always remove the Travel
Guard before operating the Sparx Sharpener.
sparxhockey.com/howto
Lever Dock (B). Press the
Clamp Lever is
Guard. Release the Clamp Lever.
3
PLUG IN THE POWER CORD
Plug the Power Cord into the
the sharpener. Plug the other end into a wall outlet. Toggle the
switch on the Power Input Port
4
INSTALL THE GRINDING RING
While holding the Grinding Ring Arbor
Ring (B) on the Grinding Ring Arbor
Thumb Nut
replace and tighten the
the Head Unit.
Power Input Port on the side of
to the on position (I=on, 0=off).
(C), slide the Grinding
(C), label facing out, and
(A) until hand-tight . Close
C B A
SETUP
11