SPARX SHARPENER 3 Bedienungsanleitung Seite 22

3
READING THE BEAM
Flick the tilt bar up and down to ensure it's settled on the steel.
The three lights on the front of the BEAM will show an even
edge or direct you which side of the edge is high. Head to the
Sparx Hockey app for an exact reading and recommendations.
OPERATION
18
4
ADJUSTING THE ALIGNMENT
If your BEAM says "EDGES GOOD", your sharpener is aligned
and there's no need for adjustments. If your Sparx Sharpener
is not properly aligned, the Sparx BEAM and App will provide
a recommendation to get your sharpener aligned and skate
edges even. Press the align button on the keypad and insert the
Adjustment Driver (A) into the Adjustment Driver Slot (B) and
adjust in the direction as recommended in the app.
B
5
SHARPEN YOUR SKATES
Enter the amount of cycles recommended by the Sparx Hockey
app and resharpen your skates.
6
DEBURR YOUR SKATES
Repeat the deburring process to ensure your BEAM gives you a
proper reading.
7
RECHECK YOUR EDGES
Repeat steps 2-7, until you have achieved "EDGES GOOD" in the
Sparx Hockey app. Once you have an even reading, your edges
are even and the Sparx Sharpener is properly aligned.
A