Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
MOVE THE CARRIAGE INTO POSITION
Using the
Left
and
the
Grinding Ring
off the toe of the skate blade 1/4 inch.
4
ADJUST THE GRINDING RING HEIGHT
Lift the
Head
Unit. Locate the red
(A). Turn the knob left to raise the height or right to lower the
height until the
Grinding Ring
knob is labeled 1-8, with 8 being the highest setting for the
Grinding Ring
and 1 being the lowest setting.
A
5
INSPECT THE CONTACT POINT
U
sing the
Left
and
Ring
to the skate blade. Inspect its contact point and be sure
it is in its desired position. Repeat steps 4 and 5 until the
Grinding Ring
makes contact at the desired position.
6
END MOVE MODE
Press the
Move Button
back to its home position.
OPERATION
14
Right Buttons
on the Keypad, back
Height Adjustment Knob
is at the desired height. The
Right
Buttons, touch the
Grinding
again to send the
Grinding Ring
SELECTING THE NUMBER
Of CyCLES
When the sharpener moves the
Grinding Ring
skate blade once, it is called a cycle.
When sharpening your first pair of skates, we recommend
sharpening with six cycles. This allows the Sparx BEAM
an accurate reading on the alignment of your sharpener.
We have found that four cycles will handle normal wear and tear
(and even small nicks) from one to four hours of skating between
sharpenings. For brand-new steel or when changing
hollow depths, we recommend using ten cycles to ensure you
completely reset the skating surface of the blade.
1
ADJUST THE CYCLE COUNT
Use the
Left
and
Right Buttons
adjust the number of cycles desired. The number of cycles
selected will be illuminated on the
out and back over the
to give you
TM
Grinding Ring
(A) on the
Keypad
to
Cycle Counter
(B).
B
A
Werbung
