SPARX SHARPENER 3 Bedienungsanleitung Seite 19

SHARPENING SKATES
Once you have loaded the skate, closed the
adjusted the height of the Grinding
sharpening.
To cancel the cycles at any point during the sharpening, press the
Cancel Button once. This will send the
position at the end of its current pass.
1
BEGIN SHARPENING
Press the Play Button. Once the button has been pressed, it
will change from white to blue and the sharpening process will
begin.
Upon pressing the Play Button, the
Cycle Counter
motor will turn on. The
cycle number until that cycle (out and in) is completed. The
sharpener will continue to run until all cycles have been performed.
At the completion of the final cycle, the end of sharpening is marked
by a "cycle complete" tone and the case LEDs will turn green. The
fan will continue to run for an additional 30 seconds after the final
cycle completes.
ADDITIONAL CYCLES
If additional cycles are desired, you can reset the cycle count and
press the Play Button again.
If the Grinding Ring skips when it first makes contact
with the blade, the Grinding Ring's height is too high.
When properly set, the Grinding Ring should make a
smooth transition onto the skate blade.
Slot Covers, and
Ring, you are ready to begin
Carriage back to its home
Air Filter fan and grinding
will flash with the current
UNLOADING A SKATE
1
DISENGAGE SLOT COVERS
Move both Slot Covers (A) away from the skate.
A
2
REMOVE THE SKATE
Press and hold down the Clamp Lever
Clamp. Remove the skate from the
Clamp Lever.
A
to open the Skate
Skate Clamp and release the
OPERATION
15