SPARX SHARPENER 3 Bedienungsanleitung Seite 20

EDGE DEBURRING
To watch the How-To video, visit
We recommend using protective gloves when
deburring the skate blade.
1
DEBURR THE BLADE WITH THE STONE
Honing Stone
Press the (A) against the face of the skate blade
(B). Do not put pressure on the side of the stone closest to the
blade edge. With light pressure, press down on the lower side
of the stone (C) and slowly run the stone back and forth along
the length of the blade for four full passes.
A
C
B
2
REPEAT ON THE OPPOSITE SIDE
Turn the skate over. Repeat step 1 on the opposite side of
the blade.
3
DEBURR THE BLADE WITH THE STROP
Press the Leather Strop (A) against the edge of the skate blade
(B) at a 45 degree angle. With light pressure, slowly run the
strop back and forth along the length of the edge for four full
passes
A
B
OPERATION
16
sparxhockey.com/howto
4
REPEAT ON THE OPPOSITE SIDE
Turn the skate over. Repeat step 3 on the opposite edge of
the blade.
When deburring coated steel, make sure to only use the
Leather Strop or the Coated Steel Kit (sold separately) to
ensure you do not remove or damage the coating.