Progress PCD46103X Benutzerinformation Seite 24

Problem
The display shows an error code
that is not in this table.
The descaling procedure is inter‐
rupted before it finishes.
The descaling procedure is inter‐
rupted before it finishes.
There is no water inside the
grill- / roasting pan after the des‐
caling procedure.
There is dirty water on the bottom
of the cavity after the descaling
cycle.
The cleaning function is interrup‐
ted before it finishes.
The cleaning function is interrup‐
ted before it finishes.
There is too much water on the
bottom of the cavity after the end
of the cleaning function.
There is no good performance of
the cleaning procedure.
There is no good performance of
the cleaning procedure.
There is no good performance of
the cleaning procedure.
24 ENGLISH
Possible cause
There is an electrical fault.
There was a power cut.
The function was stopped by the
user.
You did not fill the water drawer
to the maximum level.
The grill- / roasting pan is on a
wrong shelf position.
There was a power cut.
The function was stopped by the
user.
You sprayed too much detergent
in the appliance before the acti‐
vation of the cleaning cycle.
The initial oven cavity tempera‐
ture of the steam cleaning func‐
tion was too high.
You did not remove the side grids
before the start of the cleaning
procedure. They can transfer
heat to the walls and decrease
the performance.
You did not remove the accesso‐
ries from the appliance before the
start of the cleaning procedure.
They can compromise the steam
cycle and decrease the perform‐
ance.
Remedy
• Deactivate the oven with the
house fuse or the safety
switch in the fuse box and ac‐
tivate it again.
• If the display shows the error
code again, contact the Cus‐
tomer Care Department.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling agent /
water is present in the water
drawer body.
Repeat the procedure.
Remove the residual water and
the descaling agent from the bot‐
tom of the oven. Put the grill- /
roasting pan on the first shelf po‐
sition.
Repeat the procedure.
Repeat the procedure.
Cover all parts of the cavity with a
thin layer of the detergent. Spray
the detergent evenly.
Repeat the cycle. Run the cycle
when the appliance is cold.
Remove the side grids from the
appliance and repeat the func‐
tion.
Remove the accessories from the
appliance and repeat the func‐
tion.