Troubleshooting - Progress PCD46103X Benutzerinformation

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or operate
the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display does not show the
time during the off status.
The food sensor does not oper‐
ate.
It takes too long to cook the
dishes or they cook too quickly.
Steam and condensation settle
on the food and in the cavity of
the oven.
The display shows "C2".
Possible cause
The oven is not connected to an
electrical supply or it is connected
incorrectly.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic switch-off is acti‐
vated.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
The display is deactivated.
The plug of the food sensor is not
correctly installed into the socket.
The temperature is too low or too
high.
You left the dish in the oven for
too long.
You want to start the Defrost
function, but you did not remove
the food sensor plug from the
socket.
Remedy
Check if the oven is correctly
connected to the electrical supply
(refer to the connection diagram if
available).
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Refer to "Automatic switch-off".
Refer to "Using the Child Lock".
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.
Touch and at the same
time to activate the display again.
Put the plug of the food sensor as
far as possible into the socket.
Adjust the temperature if neces‐
sary. Follow the advice in the
user manual.
Do not leave the dishes in the
oven for longer than 15 - 20 mi‐
nutes after the cooking process
ends.
Remove the food sensor plug
from the socket.
ENGLISH 23