Description Of The Appliance; Assembling The Appliance; Instructions For Use - Silvercrest SDM 1500 A1 Bedienungsanleitung

DESCRIPTION OF THE APPLIANCE

A - Steam dispensing button
B - Handle
C - Swivel cord storage hook
D - Handle release button
E - "ON" indicator light
F - Tank release lever
G - Motor body
H - Water tank
I - Filter
J - Fixed cord storage hook
K - Steam head
L - Washable cloth
M - Power supply cable
N - Accessory for carpet cleaning
O - Washable cloth velcro couplings
P - Steam discharge nozzle

ASSEMBLING THE APPLIANCE

Proceed as follows after removing the appliance from the box:
Assemble the motor body to the steam head (Fig. 2). Tighten the screw supplied to lock the
components (Fig. 3).
Warning!
Check the tightening of the screw from time to time: steam head (K)
could come off from the motor body (G).
Press the handle release button (D). Lift the handle until it is aligned with the motor body (Fig.
4-5).

INSTRUCTIONS FOR USE

Totally unwind the power cord. To make the operation easier, turn the hook (C) downwards.
Remove the tank. Lift the tank release lever upwards as shown by the arrow (Fig. 6). At the
same time tilt and remove the tank. Turn the tank upside-down. Remove the cap (Fig. 7). Fill
the tank with fresh water by positioning it directly under the tap up to the lower rim of threa-
ding (Fig. 8). Screw the cap back on, but not with excessive force.
Warning!
If the tap water is particularly hard, use a mixture of 50% tap water
and 50% demineralised water.
Put the tank back in, paying attention to match the tank valve with the pin in the appliance
seat (Fig. 9). Press the tank all the way down until it is completely inserted and check that
EN
IT
EN 7