Restore Factory Settings; Maintenance And Cleaning; General Information About Radio Operation - HomeMatic IP HmIP-FBL Installations- Und Bedienungsanleitung

RestHre factHrly settings
9 RestHre factHrly settings
The factory settings of the device
can be restored. If you do this, you
will lose all your set
To restore the factory settings of the
blind actuator, please proceed as fol-
lows:
• Press and hold down the system
button (A) for at least 4 seconds
using a VDE screwdriver, until the
LED quickly starts flashing orange.
• Release the system button again.
• Press and hold down the system
button again for 4 seconds, until
the LED lights up green.
• Release the system button to finish
the procedure.
The device will perform a restart.
After the restart, you can again integra-
te your device into your Homematic IP
system.

10 Maintenance and cleaning

The product does not require any
maintenance. Enlist the help of an
expert to carry out any mainte-
nance or repairs.
The mains voltage must be dis-
connected before the device is
removed (trip the miniature cir-
cuit-breaker). Only qualified elec-
tricians (to VDE 0100) are permit-
ted to carry out work on the 230 V
mains.
Clean the device using a soft,
lint-free cloth that is clean and
dry. You may dampen the cloth a
little with lukewarm water in order
to remove more stubborn marks.
Make sure that no moisture will
ingress into the housing. Do not
use any detergents containing
solvents, as they could corrode
the plastic housing and label.
11 General infHrmatiHn aaHut
radiH HmeratiHn
Radio transmission is performed on
a non-exclusive transmission path,
which means that there is a possibility
of interference occurring. Interference
can also be caused by switching ope-
rations, electrical motors or defective
electrical devices.
The range of transmission within
buildings can differ greatly from
that available in the open air. Besi-
des the transmitting power and
the reception characteristics of
the receiver, environmental fac-
tors such as humidity in the vicini-
ty have an important role to play,
as do on-site structural/screening
conditions.
Hereby, eQ-3 AG, Maiburger Str. 29,
26789 Leer/Germany declares that the
radio equipment type Homematic IP
HmIP-FBL is in compliance with Direc-
tive 2014/53/EU. The full text of the EU
declaration of conformity is available at
the following internet address:
www.homematic-ip.com
23