Surface-Mounting Box Installation - HomeMatic IP HmIP-FBL Installations- Und Bedienungsanleitung

tart-um
• Connect an external blind/shutter
push-button to connecting termi-
nal S1 and S2:
- Connecting terminal S1 (G):
"Down"
- Connecting terminal S2 (H): "Up"
• Connect the neutral conductor of
the motor to the neutral conductor
of the house installation.
• Connect the phase connection of
the blind/shutter push-button with
the phase conductor of the house
installation.
• Fix the actuator to an appropriate
flush-mounting box. If required,
you can remove the fixing lug (A)
• Close the flush-mounting box
using an appropriate cover
• Switch the fuse of the power cir-
cuit on again to activate the pairing
mode of the device
ring" on page
L
N
N
M
2 1
Figure 2
6.2.2 Surface-mounting box
installation
To install the blind actuator in a sur-
face-mounting box, please proceed as
follows:
• Switch off the fuse of the power
circuit
(see „6.3 Pai-
20).
1
2
• Connect the switched phase con-
ductors for connecting terminals 1
and 2 to the motor as follows:
- Connecting terminal 2 (C): "Up"
- Connecting terminal 1 (D):
"Down"
• Connect the phase conductor to
connecting terminal L (E)
• Connect the neutral conductor to
connecting terminal N (F)
• Connect an external blind/shutter
push-button to connecting termi-
nal S1 and S2:
- Connecting terminal S1 (G):
"Down"
- Connecting terminal S2 (H): "Up"
• Connect the neutral conductor of
the motor to the neutral conductor
of the house installation
• Connect the phase connection of
the blind/shutter actuator with the
phase conductor of the house ins-
tallation
• Fix the actuator to an appropriate
surface-mounting box (e.g. Abox
025 or Abox 040) (see figure 3)
• Fix the actuator to the holding
mandrel using the fixing lug. Screw
the actuator if required
• Close the surface-mounting box
using the corresponding cover
• Switch the fuse of the power cir-
cuit on again, to activate the pai-
ring mode of the device
Pairing" on page
(see „6.3
20).
19