Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OmeratiHn
7
OmeratiHn
After setup, you can perform initial
operating functions via the external
blind/shutter push-button:
• Short button press button S1 or S2:
The motor for the blinds/shutters/
awnings moves into the corres-
ponding end position.
• Short button press opposite direc-
tion: The motor stops.
• Long button press: The motor is
controlled so that you can adjust
the slat position of the blind.
8 TrHualeshHHting
8.1
Command not confirmed
If at least one receiver does not con-
firm a command, the device LED
lights up red at the end of the failed
transmission process. The failed trans-
mission may be caused by radio in-
terference
(see „10 Maintenance and
cleaning" on page
caused be the following:
• Receiver cannot be reached.
• Receiver is unable to execute the
command (load failure, mechanical
blockade, etc.).
• Receiver is defective.
8.2
Duty Cycle
The duty cycle is a legally regulated
limit of the transmission time of de-
vices in the 868 MHz range. The aim
of this regulation is to safeguard the
operation of all devices working in
the 868 MHz range. In the 868 MHz
frequency range we use, the maxi-
mum transmission time of any device
23). This may be
is 1% of an hour (i.e. 36 seconds in an
hour). Devices must cease transmissi-
on when they reach the 1% limit until
this time restriction comes to an end.
Homematic IP devices are designed
and produced with 100% conformity to
this regulation.
During normal operation, the duty
cycle is not usually reached. However,
repeated and radio-intensive pair pro-
cesses mean that it may be reached
in isolated instances during start-up
or initial installation of a system. If the
duty cycle limit is exceeded, the device
may stop working for a brief period.
The device starts working correctly
again after a short period (max. 1 hour).
8.3
Adjustment of the slats not
possible
If it is not possible to control the slats
of a blind or if they do not move when
activated, this may be due to the drive
motors. In this case the delay before
the motor starts is too long.
This behaviour can be corrected by
using the "Compensation for delay of
motor start" setting in the device con-
figuration. We recommend setting this
value to 0.2 seconds.
21
Werbung
