Parkside Performance PRDSP 20-Li C2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 61

˜ Troubleshooting
m
WARNING! Risk of accidental contact of spray materials with skin and eye!
u
Always wear appropriate personal protection equipment as instructed by the chemical
manufacturer when using, preparing, handling, spraying, or disposing of chemicals . This
equipment includes at least goggles, gloves, respiratory protection and protective clothing .
u
Before starting to work with the product, squeeze down the trigger
been released completely . If the pressure has not been released beforehand, chemicals may
splash out in an uncontrolled manner when working with the product .
u
After work, carry out a test run with clean water .
Fault
The product cannot be
switched on .
The product does not spray .
A leakage occurs .
Possible cause
[ 18 ]
The battery pack is not
inserted properly .
[ 18 ]
The battery pack is empty .
No pressure present .
No chemicals in the spray
3 ] [
tank .
[ 12 ]
Nozzle accessories
[ 33 ]
cone spray head are
blocked .
[ 36 ]
The small filter is blocked .
Related parts are not properly
connected .
The sealant ring is damaged .
28 ] [
until the pressure has
Solution
Insert the battery pack
properly .
Charge the battery pack
Switch off the product: Press
the power button
Fill the spray tank
chemicals .
Switch off the product, remove
the battery pack
release the pressure .
or
Clean the nozzle
12 ] [
accessories
[ 33 ]
spray head
a needle through them
(see "Cleaning and care") .
Switch off the product, remove
the battery pack
release the pressure .
Clean the small filter
running water using a brush
(see "Cleaning and care") .
Switch off the product, remove
the battery pack
release the pressure .
Connect the related parts
properly .
Switch off the product, remove
the battery pack
release the pressure .
Replace the sealant ring .
18 ] [
18 ] [
.
14 ] [
.
3 ] [
with
18 ] [
and
or the cone
by pushing
18 ] [
and
36 ] [
under
[ 18 ]
and
[ 18 ]
and
GB/IE 59