Parkside Performance PRDSP 20-Li C2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 56

˜ Filling the spray tank
m
WARNING! Risk of accidental
contact of spray materials with
skin and eye.
u
Always wear appropriate personal
protection equipment as instructed
by the chemical manufacturer when
using, preparing, handling, spraying, or
disposing of chemicals . This equipment
includes at least goggles, gloves,
respiratory protection and protective
clothing .
u
Avoid accidental starting . Ensure the
product is switched off and the battery
[ 18 ]
pack is removed from the product .
u
The maximum volume of the spray
3 ] [
tank is 16 litres . Do not overfill the
spray tank!
NOTE
u
Thoroughly clean and rinse measuring
containers that are used for filling the
3 ] [
spray tank and for pre-mixing spray
materials .
26 ] [
u
The basket filter
can clog or damage the pump from
entering the spray tank .
u
Always reinsert the basket filter before
reinstalling the spray tank cover
u
Use only with plant protection products
approved by local/national regulatory
authorities for plant protection products
for use with backpack sprayers .
Before filling the spray tank with
spray solution
1 . Carry out a test run with fresh water . Check
all parts of the product for leaks .
Filling a clean spray tank
1 . Stand the spray tank
54 GB/IE
prevents debris that
8 ] [
.
3 ] [
on a level surface .
2 . Unscrew and remove the spray tank
8 ] [
cover . Check if the basket filter
correctly placed (Fig . E) .
3 . Carefully pour the spray solution into the
[ 3 ]
spray tank .
4 . Do not fill the spray tank
maximum mark .
5 . After filling, fit the spray tank cover
Tighten the spray tank cover firmly .
NOTE
u
Fix a tag on the product to note what
chemical is used .
m
WARNING!
u
Never attempt to fill the spray tank
while carrying it .
Changing the spray material
If any spray material is left in the spray tank
1 . Unscrew the spray tank cover
remove the basket filter
2 . Pour the spray material from the spray
[ 3 ]
tank into a container approved for
chemicals . Do not store chemicals in the
spray tank for a prolonged period .
3 . Use clean water to clean and rinse the
[ 3 ]
spray tank and accessories . A small
amount of mild household detergent may
be added .
4 . Pour in the new spray material (see "Filling
the tank") .
˜ Operation
˜ Switching on and off
(Fig . B)
Switching the product on sets the product into
standby . The product does not spray until the
28 ] [
trigger is squeezed while the product is
switched on .
Switching on
Press the power button
o
26 ] [
is
3 ] [
above the
8 ] [
.
3 ] [
[ 3 ]
:
8 ] [
and
[ 26 ]
.
[ 14 ]
.