Werbung
Verfügbare Sprachen
Verfügbare Sprachen
17. Thread the connector body (d) with the ferrule on to
the fiber as far as it will go.
Cleave tool
1 Trigger
2 Adapter plate
3 Jaw for fiber limit stop
4 Jaw with diamond
22. Insert the connector into the cleave tool (C)
as far as the limit stop and hold the connector in
position. The fiber extends out of the cleave tool (C).
16
18. Screw the forcing nut (b) and connector body (d)
tight.
19. When bolting them together, make sure that the
buffer and Kevlar clamp (c) does not skew.
20. Push the anti-kink sleeve (a) onto the forcing nut (b).
Note: The fiber should extend at least 30 mm out of the
ferrule. Otherwise the connector must be fitted again.
21. The cleave tool is already adjusted for the cleaving
of the fiber of the BFOC connector.
23. Press the trigger (1) slowly until you hear a click.
24. Dispose of the fiber remnants in the supplied
container (E).
Assembly Instructions
A5E02368528-4
Werbung
