What Should I Do If The Oven Doesn't Work - Küppersbusch EKDG6551.0 Bedienungsanweisung Mit Montageanweisungen

EN

What should I do if the oven doesn't work?

WARNING! Any type of repair must only be
done by a specialised technician. Any repair
done by a person not authorised by the
manufacturer is dangerous.
You do not need to contact Technical Assistance
to resolve the following questions:
 The display is not showing! Check if:
- The time indication has been switched off
(see section on Basic Settings).
 Nothing happens when I press the keys!
Check if:
- The Safety Block is active (see section on
Basic Settings).
 The oven does not work! Check if:
- The plug is correctly fitted in the socket.
- The oven's power is switched on.
 When the oven is operating I can hear some
strange noises! This is not a problem.
- It has to do with the operating noises that
can occur during the cooking process, e.g,
by the water pumps in the steam generator.
- The steam inside the cavity produces a
pressure build-up and sometimes the cavity
walls may produce noise when they react to
the pressure.
- This noises are normal, there is no problem.
 The food doesn't heat up or heats very
slowly! Check if:
- You have selected the correct operating
times and temperature setting.
- The food you have put inside the oven is a
larger amount or colder than you usually put
in.
 If the message "Err_" appears in the
display, please contact the Customer Care.
71
 The appliance still makes a noise after the
cooking process is finished! This is not a
problem.
- The cooling fan keeps on working for some
time. When the temperature has dropped
sufficiently, the fan will switch itself off.
 The oven switches on but the interior light
does not go on!
- If all the functions work properly it is
probable that the lamp has blown. You can
keep on using the oven.
Replacing the light bulb
To replace the light bulb, proceed as follows:
- Disconnect the oven from the power supply.
Take the plug out of the socket or switch off
the oven's power circuit.
- Unscrew and remove the glass light cover
(1).
- Remove the light bulb (2). Warning! The
bulb may be very hot.
- Fit a new G9 230V / 25W halogen bulb.
Follow the lamp manufacturer's instructions.
- Screw the glass light cover into place (1).
- Connect the oven again to the power supply.