Installation Instructions; Before Installation; After Installation - Küppersbusch EKDG6551.0 Bedienungsanweisung Mit Montageanweisungen

Installation instructions

Before installation

Check that the input voltage indicated on the
characteristics plate is the same as the voltage of
the power outlet you are going to use. The rating
plate is located on the front part of the cavity and
it is only visible after opening the door.
Open the oven door and take out all the
accessories and remove the packing material.
Warning! The front surface of the oven may be
covered in a protective film. Before using the
oven for the first time, carefully remove this film,
starting on the inside.
Make sure that the oven is not damaged in any
way. Check that the oven door closes correctly
and that the interior of the door and the front of
the oven opening are not damaged. If you find
any damage contact our Customer Care Centre
on the number supplied on the back cover of this
handbook.
DO NOT USE THE OVEN if the power cable or
the plug is damaged, if the oven does not function
correctly or if it has been damaged or dropped.
Contact our Customer Care Centre on the
number supplied on the back cover of this
handbook.
Put the oven on a flat and stable surface. The
oven must not be installed close to any sources of
heat, radios or televisions.
During installation follow the instructions supplied separately
,
During installation, make sure that the power
cable does not come into contact with any
moisture or objects with sharp edges and the
back of the oven. High temperatures can
damage the cable.
Warning: after the oven is installed you must
make sure you can access the plug.

After installation

The oven is equipped with a power cable and a
plug for single phase (household) current,
230-240V ~ 50Hz.
If the oven is to be installed on a permanent
basis it must be installed by a qualified
technician. In such a case, the oven should be
connected to a circuit with an all-pole circuit
breaker with a minimum separation of 3 mm
between contacts.
WARNING: THE OVEN MUST BE EARTHED.
The manufacturer and retailers do not accept
responsibility for any damage that may be
caused to persons, animals or property if these
installation instructions are not observed.
The oven only functions when the door is
closed correctly.
Before the first use, clean the inside of the oven
and the accessories, following the cleaning
instructions given in the "Oven cleaning" section.
EN
.
74