Operation With The Ir Remote Control Ir-7 - EuroLite AKKU Mini IP UP-4 QCL Spot MK2 Bedienungsanleitung

Operation with the IR remote control IR-7

The device must be activated for remote control. For this, set menu item IrYE to IrYE. When actuating a
button, always direct the remote control towards the sensor (see Description of the Device). There must be
no obstacles between remote control and the sensor.
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose, on
the rear side of the remote control press the small bar with the groove to the right and
at the same time remove the battery support. For operation, one 3 V button cell type
CR 2025 is required. When inserting, pay attention that the positive pole of the button
cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
Button Function
Press once: LEDs off
BLACKOUT
Press again: return to the last mode.
Automatic mode; press the AUTO key repeatedly to
switch through auto programs (CC, CP);
AUTO
speed selection with (+)/(‒)
Quick speed is adjusted by pressing the SPEED button
repeatedly.
SOUND Sound control (SUn); microphone sensitivity with (+)/(‒)
Strobe effect for automatic mode, sound control and
STROBE preset colors (0-9); flash rate setting with (+)/(‒);press
STROBE button again to stop the strobe effect
Switches the values of the auto programs (CC, CP, dE)
between 00 and 99
SPEED
Quick speed selection is adjusted by pressing the
SPEED button repeatedly. (speed values :20-50-80-99)
SENSITIVITY
No function
DMX/%
Activate preset colors manually, two modes:
Mode A:
1. Press the MANUAL button, then press R, G, B, W, A
or UV to choose the desired color.
2. Press the color once for 20% brightness;
3. Press a 2nd time for 40% brightness;
4. Press a 3rd time for 60% brightness;
MANUAL
5. Press a 4th time for 80% brightness;
R/G/B/W/A/UV
6. Press a 5th time for 100% brightness
Mode B:
1. Press the MANUAL button, then press R, G, B, W, A
or UV to choose the desired color.
2. Press (+) or (‒) to either increase or decrease the
brightness.
Color fade (dE), use (+)/(‒) to set the FADE program
FADE
speed
0-9 Preset colors, intensity setting with (+)/(‒)
18/20 00150545, Version 1.0