Hameg Instruments HO79-6 Handbuch Seite 56

Forms:
Parameters: None.
9.3 *ESR?
Description: Standard Event Status Register Query. Reading this register clears it. This
Forms:
Parameters: None.
9.4 *IDN?
Description: Identification Query. The response from *IDN? identifies a unique
Forms:
Parameters: None.
9.5 *OPC
*OPC?
Description: Operation Complete Command/Query. The *OPC command is intended to
Forms:
Parameters: None.
9.6 *RST
Description: Reset Command. The Reset command performs a single interface reset
Forms:
Parameters: None.
9.7 *SRE
*SRE?
Description: Sets or returns the Service Request Enable Register. This register is
Forms:
Parameters: None.
9.8 *STB?
Description: Read Status Byte Query. This register is defined in IEEE-488 11.36.
Forms:
Parameters: None.
9.9 *TST?
Description: Self-test Query. A value of zero indicates the self-test has been completed
Forms:
Parameters: None.
5 6
Command and query.
register is defined in IEEE-488 11.5.1.2.
Query only.
instrument. The response consists of a single string containing four
separate fields, comma delimited.
The fields are: <manufacturer>,<model>,<serial number >,<version>
Where
<version> is divided as: <interface version/hardware version/firmware
version>
Query only.
cause the instrument to generate a flag indicating when all pending
commands have been processed. The *OPC? is intended to place an ASCII
'1' in the instrument's output buffer if all pending commands are complete.
Command and query.
and it sets the control values to the factory default values.
Command only.
defined in IEEE-488 11.3.2.
Command and query.
Query only.
without errors detected.
Query only.
Änderungen vorbehalten / Subject to change without notice