Hameg Instruments HO79-6 Handbuch Seite 53

Forms:
Parameters: PCL, HPGL, EPSon, POSTscript, PCX.
*RST Value: POSTscript.
8.7.4 :HCOPy:LANGuage:STArt (<block> | <numeric_values>);
:HCOPy:LANGuage:STArt ?;
Description: This data is sent immediately before printing. It is used to setup the printer.
Forms:
*RST Value: empty.
8.7.5 :HCOPy:LANGuage:END (<block> | <numeric_values>);
:HCOPy:LANGuage:END ?;
Description: This data is sent immediately after printing. See HCOPy:LANGuage:STArt
Forms:
*RST Value: empty.
8.7.6 :HCOPy:PORt <CENTronics | RS-232 | GPIB | SOURce>;
:HCOPy:PORt ?;
Description: Sets or returns the port where the hardcopy is sent to. SOURce means,
Forms:
Parameters: CENTronics, RS-232, GPIB, SOURce
*RST Value: CENTronics
8.7.7 :HCOPy:HEADer <OFF | ON | BORDer>;
:HCOPy:HEADer ?;
Description: These commands can be used to select between printing/plotting the
Forms:
Parameters: OFF, ON.
*RST Value: ON.
8.7.8 :HCOPy:SETUp <OFF | ON>;
:HCOPy:SETUp ?;
Description: This command can switch off the printing of the setup.
Forms:
Parameters: OFF, ON.
*RST Value: ON.
8.7.9 :HCOPy:TEXT <OFF | ON>;
:HCOPy:TEXT ?;
Description: This command can switch off the printing of the channel-labels.
Forms:
Parameters: OFF, ON.
*RST Value: ON.
Änderungen vorbehalten / Subject to change without notice
Command and query.
For example the following sequence
HCOPy:LANGuage:STArt #H1B,#H45,#H1B,#H25,#H30,#H42
HCOPy:LANGuage:END #H1B,#H25,#H30,#H41,#H1B,#H45
HCOPy:LANGuage HPGL
HCOPy can print a HPGL-hardcopy at a HPIII
Command and query.
Command and query.
the hardcopy is sent to the port where the last SCPI command is received.
Command and query.
header or not. If BORDER was selected, only the outline of the HAMEG
Logo is printed / plotted.
Command and query.
Command and query.
Command and query.
5 3