Ieee 488.2 Compliant Commands - Hameg Instruments Ho79-6 Handbuch

Forms:
Parameters: None.
8.9.2 :SYSTem:ERRor?;
Description: This query is used to obtain a description of the error encountered while
Forms:
Parameters: None.
8.9.3 :SYSTem:ELISt?;
Description: This query is an extension of SYSTem:ERRor?. This query causes the
Forms:
Parameters: None.
8.9.4 :SYSTem:UPDate;
Description: Queries the oscilloscope SETUP and writes it into HO79. This command
Forms:
Parameters: None.
8.9.5 :SYSTem:SERial:BAUD <f | MAXimum | MINimum>;
:SYSTem:SERial:BAUD?;
Description: Sets a new baud rate for the serial interface. Permissible values between
Forms:
8.9.6 :SYSTem: GPIB:ADDRess <f | MAXimum | MINimum>;
:SYSTem:GPIB:ADDRess?;
Description: Sets a new GPIB (IEEE-488) address. Addresses 0 and 15 (F) are reserved
Forms:

9. IEEE 488.2 Compliant Commands

9.1 *CLS
Description: Clear Status Command. This command has the effect of clearing the
Forms:
9.2 *ESE
*ESE?
Description: Sets or returns the Standard Event Status Enable Register.
Änderungen vorbehalten / Subject to change without notice
Query.
the command parser processed the previous commands. The response
is an error number followed by a description. If there was no error in the
previous commands, this query responds with 0,"No errors".
Note that when this query is issued twice, the second response will be
0,"No errors"because the previous command SYSTem:ERRor? deleted
the error list.
Query.
display of an error list and the deletion of the error memory.
Query.
should be used each time before reading the parameters, if the instrument
is controlled not only in remote but also in manual operation.
Query.
1200 and 115200 baud.
Command and query.
for Talk Only mode.
Command and query.
response buffer of the setup.
Command only.
This register is defined in IEEE-488 11.5.1.3.
5 5