Rs-232 Mode; Printer Mode - Hameg Instruments Ho79-6 Handbuch

0: "Talk only" mode (manually or command controlled)
1: "Device" mode under address 1
2: "
3: "
4: "
5: "
6: "
7: "
8: "
9: "
A: "
B: "
C: "
D: "
E: "
F: "Talk only" mode in combination with automatic documentation (note item 1.3.2).

3.2 RS-232 mode

Switch SW2 is for mode and baudrate selection on condition that IEEE-488 mode is
present. If switch SW1 is not set to RS-232 mode, a baudrate of 38400 baud is
automatically chosen (default).
In RS-232 mode switch SW2 determines the baudrate used for documentation and also
the way in which the documentation is started (automatic or manual).
The SW2 settings from 0 to 7 must be used if a manually started (Start button)
documentation is to be performed. These settings also permit data transfer.
0: 9600 baud
1: 4800 baud
2: 2400 baud
3: 1200 baud
4: 19200 baud
5: 38400 baud
6: 57600 baud
7: 115200 baud
The settings from 8 to F can be used for automatic documentation (please note item
1.4.3.2).
8: 9600 baud
9: 4800 baud
A: 2400 baud
B: 1200 baud
C: 19200 baud
D: 38400 baud
E: 57600 baud
F: 115200 baud

3.3 PRINTER mode

Prerequisite switch SW1 is set to 8, 9, A or B (PRINTER mode), the setting of switch SW2
determines the way documentation is called:
0: manually or command controlled
2: "
3: "
4: "
Änderungen vorbehalten / Subject to change without notice
" " "
" " "
" " "
" " "
" " "
" " "
" " "
" " "
" " "
" " "
" " "
" " "
" " "
" " "
" " "
" " "
2
3
4
5
6
7
8
9
10
11
12
13
14
4 1