Setting Up; Connecting The Telephone; Ringer Volume Setting - Geemarc ClearSound CL60 Handbuch

1 - Connecting the telephone

- Connect the handset cord.
- Open the battery door by turning around the locking tab.
Insert 4 alkaline batteries (type AA 1.5V, not supplied) in the
compartment (*). Batteries are required if you wish to
increase the ringer level up to 10 dB and if you wish to use
the "Mechanical Bell" ringer.
Battery door back in place and turn the tab to lock the lid in
place.
- Connect the line cord plug into the line socket into the rear of
the unit (*).
- Connect the other end of the line cord into the wall PTT
socket (*).

2 - Ringer volume setting

A switch located on the right side allows the ringer to be switched to
Hi, Low or Off:
: Off
: Low
: Hi
: LOUD
Note: The ring level will be increased of 10 dB if you insert
batteries.

SETTING UP

5