Settings; Setting Up; Ringer Settings; Flash (Recall) Setting - Geemarc Photophone 110 Bedienungsanleitung

Setting Up

Connect the handset to one end of the curly cord. Plug the other
end of the curly cord into the jack on the left hand side of the
PHOTOPHONE110 unit. Place the handset on the cradle.
Connect the line cord to the jack located at rear of telephone then
connect the plug at the other end of the line cord into the wall socket
or internet box*.
(*) Classified TNV-3 according to EN62368-1 standard

Ringer Settings

A switch located on the right side of the PHOTOPHONE110 unit
allows the ringer volume to be switched to HI (maximum volume),
LO (lowest volume) or OFF (if you would prefer not to be disturbed).

Flash (Recall) Setting

You can adjust the flash time by using the switch located on the
rear side of your telephone phone. There are two levels available,
100ms and 300ms. Your telephone works with a flash time for
United Kingdom and European (R=100ms), France (300ms).
When the FLASH switch 100/300 is moved, your telephone's
land line needs to stay unplugged for 10 minutes for the change
to be processed.

Receiving Volume Setting

You can alter the receiving volume during a conversation according
to your hearing requirements.
Use the Volume slide control
side of the telephone base to adjust the level. The volume
adjustment available is 6-9 dB.
The AMPLIFY button
amplification of 18 dB i.e the volume adjustment will become 12-
30B. When the amplify function is activated, the Amplify LED is lit.
INSTALLATION

SETTINGS

SETTINGS
on the telephone base provides additional
6
found on the right