Operation; Stand-Alone Mode; Control Board - EuroLite LED THA-100F COB 3200K Bedienungsanleitung

The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the device to the mains, the LED THA-100F COB 3200K theater spot starts running.
The display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP, DOWN.
It can be operated in Stand Alone via LCD display with operating buttons or alternately in DMX-controlled
mode via lighting controller.
Turn the Focus knob on the rear of the device to adjust the focus and obtain a sharp projection.

Stand-alone mode

In the stand-alone mode, you can do without a controller.
Disconnect the EUROLITE LED THA-100F COB 3200K Theater Spot from the controller.

Control Board

The Control Board offers several features: you can easily set the starting address or the brightness.
Browse through the main menu by pressing MODE. You can browse through the selection menu and confirm
your choice by pressing ENTER. You can change the selection by pressing UP or DOWN. The functions
provided are described in the following sections.
Setting DMX channel mode:
Dimming:
Slave Mode:
The device has 2 DMX channel modes. Press the MODE
button until the display shows CHANNEL. Press the ENTER
button. You can select the DMX channel mode CH03 or
CH01 via the UP or DOWN button. Confirm your choice by
pressing ENTER.
Press the MODE button until the display shows DIMMER.
Press the ENTER button to select brightness and flash
settings, respectively. You can select the desired brightness
(C00-99) or Flash speed (F00-99) via the UP or DOWN
buttons. Confirm your choice by pressing ENTER.
Press the MODE button to select the SLAVE MODE. The
devices set in this manner can now be controlled by the
master unit (s. chapter Master/Slave-operation).
22/26 00072743.DOC, Version 1.0