Networking - Abus Rwm165 Bedienungsanleitung

Networking

Networking
Up to 12 smoke alarms of type RWM165 can be networked with each other. If a
detector detects an alarm, this alarm is indicated optically and acoustically by all
networked detectors. Due to the radio connection, a maximum distance of up to
100 metres is possible between the individual detectors in rooms. The range can be
negatively influenced by the building construction and structure.
Attention! Do not network wireless smoke detectors of other models with this one.
This could lead to malfunctions!
1. Switch on the power switch at the bottom of the first smoke detector.
2. Press the code button on the bottom of the first smoke detector: the red LED
flashes approx. once per second.
– 36 –
3. Switch on the power switch at the bottom of the second smoke detector.
4. Press the code button on the bottom of the second smoke detector: the red LED
flashes approx. once per second.
5. The coding period is approx. 60 seconds. During this time, the two smoke alarms
are in coding mode. If both green LEDs of the smoke alarms light up simul-
taneously, the networking was successful. If they are not successful, the two
detectors return to the normal state after 60 seconds.
6. Repeat the procedure for all other smoke detectors to be networked. Each
additional detector must be networked with a detector that is already networked.
7. As soon as you have connected all smoke alarms to each other, press the test /
stop button on each smoke alarm and check that the alarm signal is working on
all networked smoke alarms. Also check that the red LED only works on the tested
smoke detector.
Networking
– 37 –
GB