Kärcher IVR 50/24-2 Sc Bedienungsanleitung Seite 16

7. Empty the collection container after
each use and otherwise as needed.
Note
Only move the collection container only on
its rollers. Do not use a crane, forklift or sim-
ilar means.
Remove PE dust bag
See graphics page for illustrations
Illustration H
1. Disconnect the pressure equalisation
hose from the collection container.
2. Take the collection container out of the
device.
3. Remove the fastener from the PE dust
bag.
4. Close the PE dust bag using a cable tie
or adhesive tape.
5. Dispose of the dust bag in accordance
with statutory regulations.
6. Insert the new dust bag into the collec-
tion container.
7. Place the fastener inside.
Ensure that the PE dust bag is not dam-
aged.
8. Insert the collection container into the
device and connect the pressure equali-
sation hose.
Removing the suction head
See graphics page for illustration
1. Switch off the device and disconnect
from the power supply.
2. Open the suction head lock.
Illustration I
3. Remove the suction head and put it to
one side.
Ending operation
1. Switch off the device using the on/off
switch
2. Empty and clean the collection contain-
er.
3. Remove the accessories and clean and
dry them as necessary.
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
16
Be aware of the weight of the device during
transport and storage.
1. When transporting in vehicles, secure
the device against slipping and tipping
over according to the applicable guide-
lines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. Store the device indoors only.
Care and servicing
1. Rinse off the device and accessories at
regular intervals using a suitable liquid
and allow to dry.
2. Check the bag filter regularly for dam-
age. Replace the bag filter if damaged.
Replacing the filter
See graphics page for illustration
Illustration J
1. Unscrew the hexagon screw.
2. Unscrew the screw plug.
3. Remove and replace the filter.
4. Insert the new filter.
Ensure that the filter is inserted correctly
during installation.
5. Screw in and tighten the screw plug.
6. Screw in and tighten the hexagon screw.
Replacing the bag filter
See graphics page for illustrations
Illustration K
Screws
1
Tensioning ring
2
Bag filter
3
Cleaning device
4
1. Remove the suction head. 
(see chapter Removing the suction
head)
2. Remove the filter inlay by the handles
and turn it around.
Illustration L
3. Remove the screws and disassemble
the cleaning device.
4. Loosen the tensioning ring screws.
English
Storage