Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
-> ENTER ->
UP/DOWN
SOUND-CONTROL MODE (Soun)
Press the MODE button repeatedly until "Soun" appears in the display. Now press ENTER to select from four different programme-cate-
gories, and confirm with ENTER (rGbu = RGB+UV LEDs, Str = strobe, rGb = centre LED, MiX = combination of RGB+UV LEDs, strobe and
centre LED). Using the UP and DOWN buttons, you can now select one of the sound programmes from the respective programme category.
Confirm with ENTER. Successful entry is confirmed when the display disappears for approximately one second, before displaying "Soun".
The sensitivity with which the programmes react to sound (bass impulses) can be set as required using the MIC SENSITIVITY control. Turn
anti-clockwise to reduce sensitivity and clockwise to increase sensitivity.
-> ENTER ->
UP/DOWN
COLOUR MIX (CoLo)
This mode enables you to adjust the brightness of the 3 colours of the RGB centre LED and the 4 colours of the effects LEDs separately. This
allows for a virtually unlimited number of different colours (colour mix). Press the MODE button repeatedly until "CoLo" appears in the display.
Press ENTER, and using the UP and DOWN buttons, adjust the brightness of the red LEDs (r000–r100). Confirm with ENTER. The brightness
of the green, blue and the UV LEDs can be adjusted in the same way (G000–G100, b000–b100, U000–U100). Confirm your entry with ENTER.
Successful entry is confirmed when the display disappears for approximately one second, before displaying "CoLo".
-> ENTER ->
UP/DOWN
SLAVE MODE
Press the MODE button repeatedly until "SLAV" appears in the display, then press ENTER to activate slave mode. Successful entry is
confirmed when the display disappears for approximately one second. If there is no control signal, the display characters will flash. Flashing
stops as soon as a control signal is present. Connect the slave and the master unit (same model) with a DMX cable (Master = DMX OUT,
Slave = DMX IN) and enable one of the standalone modes on the master unit (automatic-control, sound-control or colour mix). Now the
slave unit will follow the master unit.
-> ENTER
<- MODE
8
-> ENTER ->
<- MODE
/
-> ENTER ->
<- MODE
/
-> ENTER ->
<- MODE
/
-> ENTER ->
<- MODE
-> ENTER ->
<- MODE
/
-> ENTER ->
<- MODE
/
-> ENTER ->
<- MODE
/
-> ENTER ->
<- MODE
-> ENTER ->
-> ENTER ->
<- MODE
<- MODE
UP/DOWN
-> ENTER ->
-
UP/DOWN
<- MODE
-> ENTER ->
-
UP/DOWN
<- MODE
-> ENTER ->
-
UP/DOWN
<- MODE
-> ENTER ->
-
UP/DOWN
<- MODE
-> ENTER
-
<- MODE
-> ENTER
-
<- MODE
-> ENTER
-
<- MODE
-> ENTER
-
<- MODE
-> ENTER ->
<- MODE
UP/DOWN
UP/DOWN
-> ENTER
-
<- MODE
-> ENTER
-
<- MODE
-> ENTER
-
<- MODE
-> ENTER
-
<- MODE
-> ENTER
<- MODE
Werbung
Inhaltsverzeichnis
