Ir Remote Control - Cameo FLAT MOON Bedienungsanleitung

IR REMOTE CONTROL

10
Aim the infrared remote control directly at the infrared sensor on the front of the lamp. The
maximum range is approximately 8 metres. In DMX and slave modes, the spotlight's IR
sensor is deactivated.
Blackout
Auto programme
Music control
Strobe
Colour mixing
RGB + UV LEDs
Auto programme[1]
Fade
The blackout button is used to switch off the effects
LEDs, strobe and centre LED regardless of which
operating mode is enabled via the remote control (device
display = oFF). Press the blackout button again to
reactivate the previously selected mode.
The auto programme categories rGbu (RGB+UV LEDs),
Str (strobe), rGb (centre LED) and MiX (RGB+UV LEDs +
strobe + centre LED) can be activated one after another
by pressing repeatedly. Setting speed using + and -.
Select the programmes in the respective category with
the help of the numeric keys (rGbu: AP01 – AP07 = digits
1 – 7, Str: AP01 – AP09 = digits 1 – 9, rGb: AP01 – AP05
= digits 1 – 5, MiX: AP01 – AP10 = digits 1 –- 0).
The sound programme categories rGbu (RGB+UV LEDs),
Str (strobe), rGb (centre LED) and MiX (RGB+UV LEDs +
strobe + centre LED) can be activated one after another
by pressing repeatedly. Select the programmes in the
respective category with the help of the numeric keys
(rGbu: AP01 – AP07 = digits 1 – 7, Str: AP01 – AP09 =
digits 1 – 9, rGb: AP01 – AP05 = digits 1 – 5, MiX: AP01
– AP10 = digits 1 – 0). Setting microphone sensitivity
using the MIC SENSITIVITY control.
Activates the strobe effect. Select the strobe pro-
grammes AP01 – AP09 with numeric keys 1 – 9. Set the
strobe speed with + and -.
Press MANUAL, then select the colour by pressing R, G, B
or UV. Adjust the brightness using + and - (A, W without
function, centre LED without UV).
Direct activation of the MiX auto programmes AP12
– AP14 (Fade). Select the 3 programmes by pressing
repeatedly. Setting speed using + and -.