Configuring The Prismaconnect Module - Lowenstein Medical Prismaconnect Gebrauchsanweisung

4 Preparation and operation
Result
4.3 Configuring the prismaCONNECT
4.3.1 prismaLINE (WM100TD)
Requirement
Result
4.3.2 prismaVENT (WM110TD, WM120TD)
Requirement
42 EN prismaCONNECT
The prismaCONNECT module has been removed.
The symbol disappears from the display of the therapy
device.
module
• The prismaCONNECT module is connected
Connecting the prismaCONNECT module", page
• The therapy device is switched on and is in Standby mode
(see instructions for use of the therapy device).
1. Select the network settings on the therapy device: Expert
sector | Main Menu | Device | Network (see instructions
Additional information for hospital personnel).
2. If required, select Type (default setting is DHCP).
DHCP: The prismaCONNECT module is assigned a
dynamic IP address. If there is no DHCP server available,
the IP address is assigned via zeroconf/Auto-IP in the
range from 169.254.1.0 to 169.254.254.255.
Manual: configure the static IP address and a subnet
mask.
It is also optionally possible to set a gateway and DNS.
prismaCONNECT is configured.
The settings are saved in the prismaCONNECT module.
• The prismaCONNECT module is connected
Connecting the prismaCONNECT module", page
• The therapy device is switched on and is in Standby mode
(see instructions for use of the therapy device).
1. Select the network settings on the therapy device: Expert
sector | Main Menu | Device | Network .
2. Select DHCP On or Off.
(see "4.1
39).
(see "4.1
39).