Bauknecht BIK5S DP8F2 ES Bedienungsanleitung Seite 31

CLEANING AND MAINTENANCE
Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
EXTERIOR SURFACES
. Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
. Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with a
damp microfibre cloth.
INTERIOR SURFACES
. After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues To
dry any condensation that has formed as a result of
cooking foods with a high water content, let the oven
to cool completely and then wipe it with a cloth or
sponge.
. Activate the "Smart Clean" function for optimum
cleaning of the internal surfaces.
. Clean the glass in the door with a suitable liquid
detergent.
. The oven door can be removed to facilitate cleaning.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
WATER DRAWER MAINTENANCE
Caution: The water drawer is not suitable for
dishwasher use: risk of damage!
At the end of each cooking cycle with steam, after
about 30 min the oven automatically performs a drain
cycle lasting about one minute, thus transferring all
the water in the system to the extractable drawer.
Once completed the auto-drain, proceed as follows:
REPLACING THE LIGHT
1. Disconnect the oven from the power supply.
2. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
3. Reconnect the oven to the power supply.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
1. Press the top of the drawer front cap, indicated
2. Grasp the handle and pull out the water drawer.
3. Remove the lid of the water drawer.
4. Empty the water drawer and clean it.
5. Dry the different components by using a soft cloth.
6. If necessary, allow the drawer to air dry without
7. Replace the water drawer lid.
8. Re-insert the washed and dried removable water
9. Press the bottom of the drawer front cap to
Note: If needed, a manual drain cycle can be performed:
press the Cleaning icon
navigating with the + and - buttons, select the Drain
option and press the icon
the water in the system, conveying it to the extractable
drawer.
Note: Avoid to leave the water in the system more than 2
days.
Use only room temperature water when filling the
water drawer: hot water may affect the operation of
the steam system. Use only drinking water.
BOILER
To ensure that the oven always works at optimum
performance and to help prevent the build-up of
limescale deposits over time, we recommend using
the "Drain" and "Descale" functions regularly.
After a long period of non-use of the "Forced Air +
Steam" function, it is higly suggested to activate
a cooking cycle with the empty oven by filling
completely the tank.
Please note: 40 W/230 ~ V type G9, T300°C halogen bulbs.
The bulb used in the product is speci cally designed for
domestic appliances and is not suitable for general room
lighting within the home. Light bulbs are available from our
After-sales Service.
- If using halogen bulbs, do not handle them with your
bare hands as your ngerprints could cause damage. Do
not use the oven until the light cover has been re tted.
Wear protective gloves.
The oven must be disconnected
from the mains before carrying out
any kind of maintenance work.
with a recess, to pull out the handle
closing it with the lid.
drawer into its housing making sure to push it all
the way down
reposition the handle.
on the UI panel and by
to start. The oven will drain